Dismiss Notice

You must be 18 or over to participate here.
Dismiss this notice to declare that you are 18+.

Anyone below 18 years of age choosing to dishonestly dismiss this message is accepting the consequences of their own actions.
WW2Talk.Com will not approve of, or be held responsible, for your choices.

3D Printing?

Discussion in 'Modelling' started by von Poop, Nov 26, 2021.

Tags:
Page 6 of 6
  1. Trackfrower

    Trackfrower Member

    I'll have a look.
    Those driers are quite good.
    It does make a difference.
    If you get a hydrometer (I think) from Ali, you can check the humidity.
    Just poke it in through the hole in front.
    I am looking at a used alternative too.
     
    Trackfrower, Oct 26, 2025
    #101
Page 6 of 6

Share This Page